How to guides

Q Series Irrigation Kits Set Up

Find out more about setting up the Irrigatia Q series

Switch 1 – Day Watering (On by default), to access Night Mode, turn this switch off.
Switch 2 – May be used in the future for external control. Leave this set to OFF (OFF by default)
Switch 3 – To Upgrade with a second pump switch to ON (OFF by default)
Switch 4 – If you want to use your second pump for liquid Feed, set this to ON. If it is set to OFF the second pump will act as a second Network (OFF by default)
Switch 5 – If you do not want a warning beeper, switch to OFF (ON by default)
Switch 6 – If you do not want to use the water level sensor, switch to OFF (ON by default)

1d-9d: Unit is set for day watering - Pump will run during the day
1n-9n: Unit is set for night watering - Pump will run during the night
10: Will show during the day if unit is set to night mode - Pump will not run
11: Will show at night if unit is set to day mode - Pump will not run
20: No water - Pump will not run as water source needs topping up
21: Low water - Pump will run, but you may need to top water source up soon
30: Pump off due to external control (ie switch 2 is set to on) - Pump will not run
81: Low power pump 1 - Pump may run, but could need cleaning, Check flow rate though short tube on pump 1 outlet, should be at least 300ml/minute
82: Low power pump 2 (not in feed mode) - Pump may run, but could need cleaning, Check flow rate though short tube on pump 2 outlet, should be at least 300ml/minute
83: High power pump 1 - Pump 1 may run but will need relacing as there is a motor fault
84: High power pump 2 - Pump 2 may run but will need relacing as there is a motor fault
85: Low power pump 2 (in feed mode) - Pump may run. If pump is loud it may be dry, check liquid feed level. Ensure pump is running 3 seconds every minute. May need cleaning
89: Low power pump 1 (when pump 2 in feed mode): Pump 2 will not run to avoid overfeeding. Follow steps for pump 1 under code 81